Electronics Compatibility? (TX, RX and Servo) with (Motor,Esc and LipoBat)

Hi,

What you think guys about this as my first radio kit...?

http://www.rcmart.com/catalog/rc-radio-futaba-3pm24gmx-channel-digital-proportional-system-24ghz-p-29392.html

If i would purchase that radio with receiver would it be compatible with the following items i already have...

I have a BL Motor and ESC Combo - Speed Passion D-Manager and Lithium Polymer Battery - Yeah Racing 5000mah 7.4v 25c...

What do you guys suggest on servo? I really don't have an idea about the compatibility of these electronics and i'm worried about if all of these won't work because of incompatibility with each other..

To summarize, i just want a (TX,RX and a Servo) that will work with my (Motor,Esc and LipoBatt)

Thanks...

Jarwin

Yes, this will work with the electronics you already have.

Not sure about whether it has a built-in BEC though. So you might want to take a servo that can handle 7.4 volts.

Correct me if I'm wrong guys.. I'm sleepy sleep

I use the 3PM transmitter and it's good, don't have any problems with it.

The only issue I have is that when I came to buy additional receivers for my other cars, I find they are quite expensive. The cheapest I could find was from A-Main at 90 US$.

Futaba are a good brand though, so hopefully my 90$ is worth it in the long run.

What's the difference between the one you linked in your post and this one?
http://www.rcmart.com/catalog/rc-radio-futaba-channel-digital-proportional-system-24ghz-3pm24ghz-p-24104.html?cPath=36_47

laNcELot wrote:

Not sure about whether it has a built-in BEC though. So you might want to take a servo that can handle 7.4 volts.

@Lance, BEC on my ESC? My ESC has a built-in BEC

Here:
Motor Specification:
Input Voltage: 4-6 cell
Watts: 215W
RPM per Volt, KV: 4200 RPM/ Volt
Motor Size: 540
Shaft Diameter: 3.175mm
Rotor Performs: STD/STD (ROM/temp)

ESC Specification:
Cont. Current: 40A
Burst Current: 160A
Resistance: 0.0015 ohm
Suitable Car: Car, Rock Crawler, 2WD Off Road
Suitable Brushless Motor: >7.5T (4000 brushless motor)
Battery" 4-9 Cell Ni-xx (NiMh or NiCd) or 2-3 Cell Li-Po

BEC Output: 6V/1.5A
Motor Type: Sensor less Brushless Motor
Diameter: 31.5mm x 27.5mm x 24mm (the hight of fan is
not included)
Weight: 30g (Without wires)

@gerg, I think they look the same base on their specs...

Sorry Guys.. I'm a total noob on this electronics.... scratch