counter steer mods on TA05 ver.2

Subject: Re: counter steer mods on TA05 ver.2 Thu Aug 11, 2011 3:58 am

from where we can get 16t or lower? whistle

Subject: Re: counter steer mods on TA05 ver.2 Thu Aug 11, 2011 7:18 am

@J.Drift Sir on my question in the previous page, what belts do i need on my setup?

If i have that setup, how many turns for the motor will run smoothly with it?

Subject: Re: counter steer mods on TA05 ver.2 Fri Aug 12, 2011 3:26 am

smokalot045 wrote:

from where we can get 16t or lower? whistle

Subject: Re: counter steer mods on TA05 ver.2 Fri Aug 12, 2011 9:06 am

smokalot045 wrote:

from where we can get 16t or lower? whistle

Tamiya has 16T pulley check at rc mart or post on LF thread im sure somebody has spare 16T pulley wink

Subject: Re: counter steer mods on TA05 ver.2 Mon Aug 15, 2011 2:57 am

@smokalot045 Sir what you are using on your setup on Rear with 30/22 pulleys?

Guys with the 6.405 final drive ration what motor suits this? I'm planning to have a hobbywing xerun 13.5T Sensored & 120a ESC bl combo. Please give me link for the guide of ratio of hobbywing, thanks! smile

Subject: Re: counter steer mods on TA05 ver.2 Mon Aug 15, 2011 3:53 am

artGear wrote:

@smokalot045 Sir what you are using on your setup on Rear with 30/22 pulleys?

Guys with the 6.405 final drive ration what motor suits this? I'm planning to have a hobbywing xerun 13.5T Sensored & 120a ESC bl combo. Please give me link for the guide of ratio of hobbywing, thanks! smile

sir i used aquare pulleys... very happy

http://cgi.ebay.com/STA100-Square-Counter-Drift-Pulley-Set-Tamiya-TA05-/380328199304

but i did little modification on the pulleys... cool

i have a question, my motor is getting hot since i've done putting the pulleys... what should i do or change? : smile

Subject: Re: counter steer mods on TA05 ver.2 Mon Aug 15, 2011 7:58 am

get the smallest pinion you can fit in there

Subject: Re: counter steer mods on TA05 ver.2 Tue Aug 16, 2011 3:18 am

thank you straw... smile

Subject: Re: counter steer mods on TA05 ver.2 Sat Mar 24, 2012 1:02 pm

If i decided to go 13T Front Center Aluminum Pulley how to do it with the stock spur holder?